mpfere.blogg.se

Cobra puch moped
Cobra puch moped












cobra puch moped

The bolt head and nut are riding tight with the seat frame on either side. It’s made of thicker, heavier cotton, but it’s still soft and comfy. The seat post hole does not expand to accommodate anything. /r/moped, or mopeddit, is for discussion and celebration of vintage mopeds on Reddit. My ape hangers needed to be pulled waaaay back for reach. Unless you have your rear rack on there just right you are going to NEED some sort of support for the rear bottom of this, cranking down the bolt on the post will only get you so far, especially if leaning back!īe aware that your bars are going to be a mighty stretch if you want to lounge with this thing. I found the sitting surface just a little too short to get my plump bottom feeling secure, you don’t have anywhere to hang the extra butt off the back of! The seat vinyl was not adhered where the sitting part goes vertical, which may stretch into place with heat and use.

cobra puch moped

The pad portion is bolted to the frame and I didn’t have any noticeable flex. after having travelled a lot, was one of the most enjoiable things i have done in my life. Build Log: 50cc 60mph Puch Magnum Moped The Dash Now that i have all the lights hooked up i installed the tach and speedo. as a teenager i purchased a puch moped and rode it from vienna to monte carlo. Total Reviews: 1 give your taco rating hereĪshley Ackley from minneapolis, MN United States Puch Cobra I recently purchased a 1984 Puch Cobra. Items per page Puch models Puch 125 SV Puch 150 TL Puch 175 SVS Puch 200.














Cobra puch moped